Hi,
I have purchased a new HX750i for my HTPC with the intention of having a silent system. I have the Corsair Link software installed and can see the Power In idling around 160W and Power Out at ~150W as we speak.
I am slightly concerned however about the control of the power supplys fan speed.
In the link software I can see the temperature of the PSU around 20.5C, the fan always seems to hover at ~470-480rpm. I don't ever see it completely stopping.
If I change the fan mode via Link from "Default Mode" to "Fixed" I can manually change it from 40% - 100% and this all works fine. When I switch back to "Default Mode" then and only then does the fan rpm drop to 0 as I would have expected. Within about 1 minute, it again turns back on though to ~480rpm again.
I just want to know why its not staying in 0rpm mode all the time under pretty much no load at all and very low temperatures? Is there a bug in the fan controller software / logic to make it only go to 0 rpm when I switch from Fixed back to Default?
If so could the likes of this be fixed via firmware update or anything?
Regards,
Mark
I have purchased a new HX750i for my HTPC with the intention of having a silent system. I have the Corsair Link software installed and can see the Power In idling around 160W and Power Out at ~150W as we speak.
I am slightly concerned however about the control of the power supplys fan speed.
In the link software I can see the temperature of the PSU around 20.5C, the fan always seems to hover at ~470-480rpm. I don't ever see it completely stopping.
If I change the fan mode via Link from "Default Mode" to "Fixed" I can manually change it from 40% - 100% and this all works fine. When I switch back to "Default Mode" then and only then does the fan rpm drop to 0 as I would have expected. Within about 1 minute, it again turns back on though to ~480rpm again.
I just want to know why its not staying in 0rpm mode all the time under pretty much no load at all and very low temperatures? Is there a bug in the fan controller software / logic to make it only go to 0 rpm when I switch from Fixed back to Default?
If so could the likes of this be fixed via firmware update or anything?
Regards,
Mark
Aucun commentaire:
Enregistrer un commentaire