Recently upgraded my cpu cooler with h110igt and had to install the corsair link. In the past I had it installed when bought my ax1200i, but when the newer versions couldn’t read my ax temps left it.
Downloaded the latest version 3.1.5525 but the h110igt temp is 0,0?!? Downgraded to the previous and the same result. Only the 2.7.5339 show the temp. Shouldn’t the latest versions work on the new aio cooler?
Also this version gets my psu temp without flashing, but when corsair link is in the systray and I right click on the icon some times my pc shutsdown right away!!! No events registered. I assume is some bad setting send to the psu… I noticed that the previous versions read the psu in single rail but these new ones put it in multirail. What is the default rail setting in this psu?
I tried an install tutorial in this forum but I don’t get why I should change my cooler firmware to an older version that is supposed to be to the h80/h100. This firmware is the code running in the cooler hardware?
Right now I only run the corair link (2.7.5361) when I want to change the fans speed and unplugged the ax psu usb.
I expect that the corsair link program work correctly with their hardware, in my case with the h110i and ax1200i, but I am not able to set it properly. Can someone help?
(in my bios the legacy usb support is off and when I install a newer version I delete the corsair folder in appdata)
Downloaded the latest version 3.1.5525 but the h110igt temp is 0,0?!? Downgraded to the previous and the same result. Only the 2.7.5339 show the temp. Shouldn’t the latest versions work on the new aio cooler?
Also this version gets my psu temp without flashing, but when corsair link is in the systray and I right click on the icon some times my pc shutsdown right away!!! No events registered. I assume is some bad setting send to the psu… I noticed that the previous versions read the psu in single rail but these new ones put it in multirail. What is the default rail setting in this psu?
I tried an install tutorial in this forum but I don’t get why I should change my cooler firmware to an older version that is supposed to be to the h80/h100. This firmware is the code running in the cooler hardware?
Right now I only run the corair link (2.7.5361) when I want to change the fans speed and unplugged the ax psu usb.
I expect that the corsair link program work correctly with their hardware, in my case with the h110i and ax1200i, but I am not able to set it properly. Can someone help?
(in my bios the legacy usb support is off and when I install a newer version I delete the corsair folder in appdata)
Aucun commentaire:
Enregistrer un commentaire