Hey All,
Just recently picked up a H110 for my FX9590 after decising the H80i wasn't quite doing the job.
Well after wrestling with this thing for quite some time I've found I can't quite get it seated correctly. I've taken off the waterblock a few times and notice the right side never gets TIM on it, leading me to believe it's not sitting right and resulting in higher than expected temperature (45c idle).
So what options do I have? The thumb screws on the right turn infinitely (gets tight but then the silver back mount thing spins). I've also never been first time successful sscrewing in the mount (always slightly off center on first screw in requiring me to adjust mount and likely resulting in smearing, still no TIM on the right side though after unmounting to check).
Idea me guru's!
Just recently picked up a H110 for my FX9590 after decising the H80i wasn't quite doing the job.
Well after wrestling with this thing for quite some time I've found I can't quite get it seated correctly. I've taken off the waterblock a few times and notice the right side never gets TIM on it, leading me to believe it's not sitting right and resulting in higher than expected temperature (45c idle).
So what options do I have? The thumb screws on the right turn infinitely (gets tight but then the silver back mount thing spins). I've also never been first time successful sscrewing in the mount (always slightly off center on first screw in requiring me to adjust mount and likely resulting in smearing, still no TIM on the right side though after unmounting to check).
Idea me guru's!
Aucun commentaire:
Enregistrer un commentaire