Hello again, I'm going round in circles with which way to mount my fans and was hoping someone with a similar setup could provide some advice. I've read loads of post and everyone has different opinions!
I have a Coolermaster HAFx case with:
230mm fan on the front as intake
H100i at top with 2x noctua NF-F12 as intake (mounted beneath the rad, so pulling - not sure if push through would be better)
A Noctua NFA-14 top rear as exhaust
A 200m side fan as exhaust to dump air from the graphics card (Sapphire 290 trix)
Does this seem sensible? -I'd prefer to blow air onto the GPU and motherboard but think this would cause too much positive pressure. And if anyone can confirm mounting the H100i fans above rather than below to push, that would be great. (It seems consensus on this forum is pushing through, not pulling - guess the manual illustration is confusing!)
Any advice is much appreciated, I've spent 3 days messing about with the PC now and my better half is starting to roll her eyes ;):
I have a Coolermaster HAFx case with:
230mm fan on the front as intake
H100i at top with 2x noctua NF-F12 as intake (mounted beneath the rad, so pulling - not sure if push through would be better)
A Noctua NFA-14 top rear as exhaust
A 200m side fan as exhaust to dump air from the graphics card (Sapphire 290 trix)
Does this seem sensible? -I'd prefer to blow air onto the GPU and motherboard but think this would cause too much positive pressure. And if anyone can confirm mounting the H100i fans above rather than below to push, that would be great. (It seems consensus on this forum is pushing through, not pulling - guess the manual illustration is confusing!)
Any advice is much appreciated, I've spent 3 days messing about with the PC now and my better half is starting to roll her eyes ;):
Aucun commentaire:
Enregistrer un commentaire