Running CL 2.7.5361
Finally, all sensors (well I think all) show in CL. No longer does the icon go away in the sys tray after a few minutes after start up. No longer do I get a memory error relate to CL.
Fix was typical. After the build was installed, I un-installed CL then reinstalled it. Rebuilt my pictograph. Done.
A few times, the data displayed went 'kerfluey' (tech term). Non-CL components (case fans, board temps) went off the charts (fans showing a rpm of 9875, temps showing 400 degrees c). Shutting down CL and restarting returned the data to normal.
Sometimes when I close the pictograph (and leave CL running) it still asks me if I want to 'save the changes' when I've made none. Some times I save, sometimes I do not. It does not seem to make a difference to CL.
Finally, all sensors (well I think all) show in CL. No longer does the icon go away in the sys tray after a few minutes after start up. No longer do I get a memory error relate to CL.
Fix was typical. After the build was installed, I un-installed CL then reinstalled it. Rebuilt my pictograph. Done.
A few times, the data displayed went 'kerfluey' (tech term). Non-CL components (case fans, board temps) went off the charts (fans showing a rpm of 9875, temps showing 400 degrees c). Shutting down CL and restarting returned the data to normal.
Sometimes when I close the pictograph (and leave CL running) it still asks me if I want to 'save the changes' when I've made none. Some times I save, sometimes I do not. It does not seem to make a difference to CL.
Aucun commentaire:
Enregistrer un commentaire